Filter
Top Products
ENG-14
You can choose the sound mode (G or K) according to
the TV set connected to your VCR.
1 After pressing the MENU, press the OK or
❿
.
Result: The Setup menu is displayed.
2 Press the corresponding
,
❷
buttons to select
the Install option.
3 Press the OK button to select this option.
Result: The Install menu is displayed.
4 Press the OK
or
❷
buttons, until the TV
System option is selected.
5 Press the OK or
❿
button to select G or K.
6 On completion, press RETURN to exit the menu.
Your DVD-VCR output channel may need to be
changed if the pictures suffer from interference or if
your TV cannot find the pictures.
Also, you can change the DVD-VCR output channel to
adjust the frequency in which information is displayed
on the screen.
1 After pressing the MENU, press the OK or
❿
.
Result: The Setup menu is displayed.
2 Press the corresponding
,
❷
buttons to select
the Install option.
3 Press the OK or
❿
to select this option.
Result: The Install menu is displayed.
4 Press the
,
❷
buttons, until the VCR Output CH
option is selected.
5 Select the required output channel (CH21~CH69)
by pressing the OK or
❿
buttons. and
➛
buttons.
CH21
.. CH36
.. CH69
6 On completion, press RETURN to exit the menu.
Then tune your television again (see page 8).
Setting the DVD-VCR Output
Channel
Selecting the RF OUT Sound
Mode (G-K)
Auto Setup
Manual Setup
Install
TV System : G
VCR Output CH : CH 36
G
K
Auto Setup
Manual Setup
TV System : G
VCR Output CH : CH 36
Install
CH:21
:
CH:36
:
CH:69
7 To change the programme number assigned to a
station press the OK button on the remote control.
(For example, To move a TV station in programme
1 to programme 3)
8 Press the
,
❷
buttons to select required position.
And then press OK again to swap the position.
9 On completion, press the RETURN button four
times to exit the menu.
Changing the Preset
Station Table