Filter
Top Products
ENG-23
3 When you are ready,
◆
Start playback or Recording.
◆
Press the
■
button.
◆
To fast-froward or rewind to the sequence at
which the counter was set to zero, press
➛➛
or
❿❿
.
➢
Some DVD-VCR information, such as the counter,
can be displayed on the television screen (unless
you have deactivated the Screen messages mode;
refer to page 16).
Press INFO.:
◆
Once to display the current function,
programme number, recording speed, date,
time and counter
◆
Twice to display the counter only
◆
Three times to display the time remaining on
the cassette
◆
Four times to clear the display
0:00:00
Using the Assemble Edit
Function
This function allows you to start a new recording at a
specific position on the cassette while maintaining a
very smooth scene change.
1 Insert the cassette to be edited in your DVD-VCR.
2 Press the
❿ll
button to start playback.
3 When you reach the position from which you wish
to start the new recording, press the
❿ll
button.
4 Press the F.ADV/STEP button again as often as
necessary to advance frame by frame, until the
exact recording position is located.
5 While the DVD-VCR is in still mode, hold the REC
button
(
●
)
down for a while to activate the
Assemble Edit function.
6 Select the source from which you wish to record by
pressing:
◆
The PROG buttons for television channels
◆
The INPUT SEL. button for the LINE input
sources
7 Press the
❿ll
button to start recording.
8 When you have finished recording, press
■
.
Using the Tape Counter
The tape counter:
◆
Indicates the elapsed time in the play and record
modes (hours, minutes and seconds)
◆
Is reset when a cassette is inserted in the DVD-VCR
◆
Allows you to find the beginning of a sequence easily
☛
If the remaining time is to be calculated
correctly, you must indicate the type of cassette
being used.
1 Insert a cassette in your DVD-VCR.
2 To set the tape counter to zero at the beginning of a
sequence:
◆
Press INFO. twice to display the counter
◆
Press CLEAR when you want to set the tape
counter to zero.