Filter
Top Products
ENG-8
Tuning Your Television for the
DVD-VCR
You must tune your television for the DVD-VCR only if
you are not using a AV cable
➢
To view pictures from your DVD-VCR when a AV
cable is used, the television must be set to the
audio/video mode (AV).
1 Switch on the television.
2 Switch on the DVD-VCR by pressing STANDBY/ON
on the front of the DVD-VCR or STANDBY/ON on
the remote control.
3 Select a programme position on the television to be
reserved for use with your DVD-VCR.
4 Insert the video cassette in the DVD-VCR. Check
that the DVD-VCR starts reading the cassette; if
not, press
❿
II
button.
5 Start a scan on your television or set the television
to UHF channel 36.
6 Fine tune the television until the pictures and sound
are obtained clearly.
7 If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the DVD-VCR
output channel (see Setting the DVD-VCR Output
Channel on page 14 and Problems and Solutions
on page 45).
8 When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
with your DVD-VCR.
Plug & Auto Set up
Your DVD-VCR will automatically set itself up when it
is plugged into the mains for the first time. TV stations
will be stored in memory. The process takes a few
minutes. Your DVD-VCR will then be ready for use.
1 Connect the coaxial cable as indicated on page 6.
(Connecting Your DVD-VCR to the TV Using the
Coaxial Cable)
2 Plug the DVD-VCR into the mains.
Result:
The Auto Setup is started automatically.
3 Select the required language by pressing the
or
❷
buttons.
4 Press OK to store the language selected.
Result: A message appears.
5 Press OK to start the auto scanning.
◆
The number of stations automatically stored by
the VCR depends on the number of stations
that it has found.
6 The current time and date are displayed
automatically. Check the date and time. if it is :
◆
Correct, Press RETURN button twice to exit the
menu.
◆
incorrect, see page 10.
➢
Auto preset can be performed by pressing
■
on
the front panel continuously for 5 seconds or
more with no tape inserted in VCR mode.