Filter
Top Products
ENG-6
Connecting DVD-VCR to the
TV using the Coaxial Cable
Display Indicators
To receive television programmes a signal must be
received from one of the following sources:
◆
An outdoor aerial
◆
An indoor aerial
◆
A cable television network
◆
A satellite receiver
☛
Make sure that both the television and the DVD-
VCR are switched off before connecting the
cables.
1 Remove the aerial or network input cable from the
television.
2 Connect this cable to the 75Ω coaxial socket
marked on the rear of your DVD-VCR.
3 Plug the coaxial cable supplied into the socket
on your DVD-VCR.
4 Plug the other end of the coaxial cable into the
connector previously used for the aerial on the
television.
5 To obtain better quality pictures and sound on your
television, you can also connect your DVD-VCR to
the television via the AV cable (see next page) if
your television is equipped with this type of
connection.
6
1 The DVD Deck is active
2 A DVD, CD, VCD, or SVCD is loaded
3 The time, counter position, time remaining or
current deck status is displayed
4 VHS tape is inserted
5 The VCR Deck is active
6 ATimer Recording is programmed or in progress.
1 2 3 4 5
TV
Inserting Batteries in the
Remote Control
You must insert or replace the batteries in the remote
control when you:
◆
Purchase the DVD-VCR
◆
Find that the remote control is no longer
working correctly
1 Push the tab in the direction of the arrow to release
the battery compartment cover on the rear of the
remote control.
2 Insert two AAA, RO3 or equivalent batteries, taking
care to respect the polarities:
◆
+ on the battery with + on the remote control
◆
– on the battery with – on the remote control
3 Replace the cover by aligning it with the base of
the remote control and pushing it back into place.
➢
Do not mix different battery types (manganese
and alkaline for example).
2
4
3
1
TV