Filter
Top Products
English-18
Setting Up the Remote to Operate Your Cable Box
Note on Using Remote Control Modes: Cable Box
When your remote control is in “CABLE” mode, the volume buttons still control your TV’s volume.
1 Turn off your cable box.
2 Press the MODE button and make sure that the CABLE LED
is illuminated.
3 Press the SET button on your TV’s remote control.
4 Using the number buttons on your remote control, enter three
digits of the cable box code listed on page 20 of this manual
for your brand of cable box. Make sure you enter three digits
of the code, even if the first digit is a “0.”
If there is more than one code listed, try the first one.
5 Press the Power button on the remote control. Your cable box
should turn on if your remote is set up correctly.
If your cable box does not turn on after set-up, repeat steps
2, 3 and 4, but try one of the other codes listed for your
brand of cable box. If no other codes are listed, try each code,
000 through 074.
OPERATION
BN68-00656A-04Eng.qxd 9/18/04 10:39 AM Page 18