Filter
Top Products
English-19
Setting Up the Remote to Operate Your DVD
Note on Using Remote Control Modes: DVD
When your remote control is in “DVD” mode, the volume buttons still control your TV’s volume.
1 Turn off your DVD.
2 Press the MODE button and make sure that the DVD LED
is illuminated.
3 Press the SET button on your TV’s remote control.
4 Using the number buttons on your remote control, enter three
digits of the DVD code listed on page 20 of this manual for
your brand of DVD. Make sure you enter three digits of the
code, even if the first digit is a “0.”
If there is more than one code listed, try the first one.
5 Press the Power button on the remote control. Your DVD
should turn on if your remote is set up correctly.
If your DVD does not turn on after set-up, repeat steps 2, 3
and 4, but try one of the other codes listed for your brand
of DVD. If no other codes are listed, try each code, 000
through 009.
Setting Up the Remote to Operate Your DVD
OPERATION
BN68-00656A-04Eng.qxd 9/18/04 10:39 AM Page 19