Filter
Top Products
Follow these steps to run the diagnostics system test on your Samsung Fliptop powered by
DIRECTV
®
.
1) Turn on your Samsung Fliptop powered by DIRECTV
®
.
2) Set the Video Source to DIRECTV in the LCD panel menu. (See page 13 for more details)
3) Slide the mode switch to the DIRECTV position to put the remote control in satellite receiver-
controlling mode, then press MENU to bring up the Quick Menu.
4) Select Settings.
5) Select Setup, then Info & Test.
6) Use arrow keys to highlight the System Test tab, then press SELECT on Run Test.
7) If your system does not pass the system test, check any of these potential trouble areas: cabling,
pointing the satellite dish, phone connection and access card.
You should run a system test several times before concluding that there is a problem. Occasional
fluctuations in the phone line or satellite signal can give temporary false readings.
Fine-Tuning the Signal
If you self-installed your satellite dish antenna, you may have already used Guided Setup to find the
dish-pointing coordinates, acquire and fine-tune the signal and run a system test. If you need to
run Guided Setup again, select Settings from the Quick Menu, then select Guided Setup. Next, press
SELECT on Satellite, then select Repeat Satellite Setup.
Other Information
Troubleshooting
62