Filter
Top Products
Usethisconnectionif yourcablesystemconnects
directlytoyourTV/VCRwithoutaconverterbox.
Withthisconnectionyou1)canuseyourTV/VCR
RemoteControltoselectchannels2)programone
or moreunscrambledchannelsfor unattended
recording.
From Cable System
75-ohm
Coaxial Cable /"F'] _ I_]_
(Not supplied) L____
-©©
_ II_i'JI_ [_o_
When using an external input signal, connect the
audio/video cable to the AUDIO IN, VIDEO IN
jacks. To use the external input jack, selet the AUX
position. Press CH. "A" or "V" button or enter "00"
with number button so that AUX appears on the
screen.
If your cable service supplies you with a converter
box you can use the basic connection shown here.
From Cabl6 System
_._l_ CATV Box,,(Notsupplied)
c5aOiha/Cable fl _ _ 13J"
With this connection you can record and view any
channel including scrambled channels. However
channel selection must be made at the cable com-
pany converter box. This means that channels
cannot be changed using the TV/VCR Remote
Control. Unattended recording is limited to one
channel at a time.
TO RECORD AND VIEW A SCRAMBLED/UN-
SCRAMBLED CHANNEL
1. Set the TV/VCR channel selector to the output
channel of the Cable Converter Box. (Ex. CH3)
2. Select the channel to be recorded or viewed on
the Cable Converter Box.
AUX
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC
that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building as close to the point of cable entry as practical.
-11-