Filter
Top Products
AUTOMATIC TIMER RECORDING
HINTS
• If there a power failure or the TV/VCR is un-
plugged for more than 10 seconds, the clock
setting and all timer settings are lost. At this
time, display will automatically return to the
Clock Set mode when you choose program set
mode.
• If two timer programs overlap, the one that
starts first has priority. When the first program
ends, the TV/VCR switches to record the re-
mainder of the second program.
• Make sure the channel you want to record is
properly tuned in advance.
• The erase-prevention tab on the cassette must
be in place (or you must put tape over the hole).
Note: A cassette without erase-prevention tab
will be ejected when in the Timer Rec mode.
• It is not necessary to press REC button for timer
recording.
• Recording begins automatically at the set Start
time.
• If you are recording using the Automatic Timer
Programmed, you may not operate the unit
manually, but, you may still stop the recording
by pressing STOP button on the TV/VCR.
Note: STOP button on the remote control unit
will not function in this mode.
• If the tape runs out before the end time, the
TV/VCR will switch to the Stop mode im-
mediately, and tape will be ejected.
• If a tape is not loaded or the erase-protection
tab is removed, the TIMER REC indicator
flashes and automatic timer recording cannot
occur. Press POWER button to stop the flash-
ing. Then, load a tape that allows recording.
CHECKING TIMER PROGRAMS
To check a program that is to be recorded using the
Automatic Timer Program when the TV/VCR is
in the Timer Record mode, turn on the TV/VCR.
Press POWER button to exit the Timer Record
mode. Then follow instructions in steps 2 to 5 on
page 22. Information which was set for program
will now appear.
To see the COUNTER, CLOCK and CHANNEL
number on the TV screen, press the SELECT but-
ton on the remote control.
SELECT
Each time you press the SELECT button on the
remote control, TV screen will change as follows.
When the Closed Caption mode is OFF:
OFF mode
4=
COUNT mode CLOCK mode
SP COUNT 1234 SP
|
When the Closed Caption mode is ON:
On Screen Display will disappear after 5 seconds.
OFF mode
CLOCK/COUNTmode
.....oH2
COUNTt_*4
This is true even if MUTE button is pressed, or
PAUSE/STILL button is pressed while recording.
However, On Screen Display will appear for 5
seconds as SELECT button is pressed.
- 27 -