Sharp LC60EQ10U Flat Panel Television User Manual


 
>>
<<
Enjoying 3D Image Viewing (For the UQ17U, TQ15U, SQ17U, SQ15U and LE657U models)
ENG 5-4
Using the 3D glasses (Continue)
Switching to 3D and 2D Mode
When viewing 3D images, you can press the power button
to switch between 2D and 3D modes. This is useful when
several people are viewing 3D images on the same TV with
some people wanting to watch in 3D and some people
wanting to watch in 2D.
Viewing 2D images
When you press and hold for less than 2 seconds while
viewing 3D images, the LED light blinks in red and the 3D
images switch to 2D images.
Viewing 3D images
When you press and hold for less than 2 seconds while
viewing 2D images, the LED light blinks in green and the 2D
images switch to 3D images.
Usage Range of the 3D Glasses
The 3D glasses can be used by receiving a signal sent from
the TV.
The 3D glasses turn off automatically after 15 seconds if no
signal is received from the TV.
Operating range
From directly the TV: approx. 5 m (within approx. 30°
horizontally and 20° vertically)
Replacing the Battery
The battery has an expected service life of approximately 75
hours.
When replacing the button battery, use only the
designated battery (Maxell branded CR2025 lithium
button battery).
1 Use the tip of a ballpoint pen or similar object to press in
on the lock.
2 While pressing in on the lock, place your fingertip in the
groove and pull out the battery holder.
Pull the battery holder all the way out.
3 Replace the battery.
Use the tip of a ballpoint pen or similar object to
remove the battery.
Insert a new battery.
Insert the battery with the negative side (-) facing up.
4 Align the battery holder with the battery slot on the 3D
glasses and slide it back into place.
Press it in until it locks.
NOTE
Take care not to reverse the battery poles (+) and (-)
when loading the battery.
Used batteries should be disposed of strictly in
accordance with the applicable local laws and
regulations.