Filter
Top Products
-10
Page 11
1. Connecting the monitor to a computer
Setting up the Monitor Network Environment
This section describes the basic procedure for using the monitor via the network.
If the network is already constructed, the monitor’s network settings may need to be changed. Please con-
sult your network administrator for assistance with these settings.
You can make network settings both on the monitor and on the computer. The following procedure is for
making settings on the computer.
Network settings on the computer
Connect a LAN cable (Category 5, cross-over type) between the computer and monitor.
Pages 12, 13
2. Setting an IP address for the computer
Adjust the IP settings of the computer to enable one-to-one communications with the monitor.
Page 14
3. Setting up a network connection for the monitor
Adjust the monitor network settings to conform to your network.
LAN cable
(commercially available)
Use Internet Explorer
(version 5.0 or later)
to make various
monitor settings.
Temporarily change
the computer’s IP
address.
•Microsoft
®
and Windows
®
are registered trademarks of Microsoft Corporation in the United States and/or
other countries.
•All other company or product names are trademarks or registered trademarks of their respective compa-
nies.
You can also make the settings of steps 2 and 3 below in the menu operation of the monitor. For details, refer
to the operation manual of the monitor. (See page 37.)