Filter
Top Products
-16
Controlling the Monitor via LAN
Controlling the Monitor
Using Internet Explorer
(Version 5.0 or later)
Complete connections to external equipment
before starting the operation. (See pages 16-
20 of the monitor’s operation manual.)
Complete the AC cord connection. (See page
21 of the monitor’s operation manual.)
1 Start Internet Explorer (version 5.0
or later) on the computer.
2 Enter “http://” followed by the
monitor IP address set by the
procedure on page 15 followed
by “/” in “Address”, and then
press the “Enter” key.
• When “DHCP Client” is set to “OFF” on
the monitor, IP address is
192.168.150.2. If you did not change
the IP address in “3. Setting up a
Network Connection for the Monitor”
(pages 14-15), enter “http://
192.168.150.2/”.
•
When “DHCP Client” is set to “ON” on
the monitor, you can confirm the IP
address that is given by the DHCP
server in the menu operation of the
monitor. For details, refer to the
operation manual of the monitor. (See
page 37.)
3 A screen for controlling the
monitor appears, ready for per-
forming various status condi-
tions, control, and settings.
After connecting the monitor to your network, enter the monitor IP address in “Address” on
Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the monitor via the network.
Note
•
When connecting the monitor to the LAN, use a
LAN cable (Category 5). When connecting the
monitor to a hub, use a straight-through cable.