Filter
Top Products
• [DISTANCE (SURROUND)]
Tile default distance setting t_)r tile speakers ill
relation to tile listening position is shown below.
When you set tile distance using the Quick Setup
(page 24), tl_e settings is automatically
displayed.
0,00 - 7.00 512)/
Be sure to change Ihe value in the Setup Display
when you ulove fl_e speakers.
[L/R] Surround speaker distance
3.00roll0 ffl}:_) from thelistening position can
(appears when you be set from 0.00 to 7.00
set [SURROUND] to meters2)(0 to 23 fl).
[YES] in the
[CONNECTION]
setting.)
]!When you perform tile Quick Setup (page 24), the
default settings are changed.
2)0.00 to 7.01 meters for North American models.
"_)3.(Mroll 11ft for Norlh American models.
• Depending on the input stream, tile [DISTANCE]
setting may not be effective.
• When the speaker distance setting is not in the
recommended range,/_1"//q_. "" mis displayed (""
being the number)./_) indicates over the
recommended distance. _1 indicates below.
• [LEVEL (FRONT)]
You can vary tile level of front speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
[I/R] Sel Ihis between 6.0 dB and
0.0 dB +6.0 dB.
[CENTER] Set this between 6.0 dB and
0.0 dB +6.0 dB.
(appears when you
set [CENTER] to
[YES] in the
[CONNECTION]
setting.)
[SUBWOOFER] Set this between 6.0 dB and
+2.0 dB +6.0 dB.
• [LEVEL (SURROUND)]
You cml vary the level of surround speakers as
li!llows. Be sure to set [TEST TONE] to [ONI
for easy adjustment.
[L/R]
0,0 dB
(appears when you
set [SURROUND]
to [YES] in the
[CONNECTION]
setting.)
Set Ihisbetween 6.(1dB and
+6.11dB.
To adjust the volume of all the
speakers at one time
Turn tile VOLUME control on tile unit, or press
VOLUME +/- on the remote.
• [TEST TONE]
The speakers will emit a test tone to adjust
[LEVEL (FRONT)] and [LEVEL
(SURROUND)].
[OFF]
[ON]
The test tone is not emitted from the
speakers.
The test tone is emitted from each speaker
in sequence while a_liusting level. When
you select one of the [SPEAKER SETUP]
items, the test tone is emitted from each
speaker in sequence.
Adjusting the speaker level by
using the test tone
1 Press Q DISPLAY when the system is
in stop mode.
Tile Control Menu display appears.
2 Press ,I,/4, to select [SETUP],
then press @.
The options l\)r [SETUP] appear.
<
O.
O.
&
3
continued_
g3us