Filter
Top Products
76
PICTURE
MEMORY
Note
If you operate the player while the picture is being
stored in memory, the player will fail to store the
picture.
◆ BLACK LEVEL
Selects the black level (setup level) for the
video (NTSC) signals output from the jacks
other than COMPONENT VIDEO OUT.
Note
This does not work with PAL format discs.
◆ BLACK LEVEL (COMPONENT OUT)
Selects the black level (setup level) for the
video (NTSC) signals output from the
COMPONENT VIDEO OUT jacks. You
cannot select this when “COMPONENT
OUT” is set to “PROGRESSIVE” (see
below).
OFF
ON
Sets the black level of the
output signal to the standard
level. Normally select this
position.
Raises the standard black level.
Use this setting when the
picture appears too dark.
To switch the video signal format
If you have selected “PROGRESSIVE” for a
TV that does not accept signals in
progressive format, or if the software’s video
signals are not suited for progressive video
signal conversion, view the image in
Interlace format.
1 Set the COMPONENT VIDEO OUT/
SCAN SELECT switch on the rear panel
of the player to “INTERLACE.”
2 Set “COMPONENT OUT” to
“INTERLACE.”
3 Reset the COMPONENT VIDEO OUT/
SCAN SELECT switch to
“SELECTABLE.”
Normally leave the switch in this
position when using the COMPONENT
VIDEO OUT jacks.
Note
“PROGRESSIVE” does not work for PAL signals.
Even if you set “COMPONENT OUT” to
“PROGRESSIVE,” the output signal is
automatically switched to interlace format for PAL
signals.
When “PROGRESSIVE” is selected in
“COMPONENT OUT”
• 4:3 OUTPUT
Adjust this when you watch progressive
signals on a standard 4:3 aspect ratio
television. If you can change the aspect ratio
on your progressive format (525p)
compatible TV, change the setting on your
TV, not the player.
Note
This does not work with PAL format discs.
Sets the black level of the
output signal to the standard
level. Normally select this
position.
Raises the standard black level.
Use this setting when the
picture appears too dark.
OFF
ON
◆ COMPONENT OUT
This will change the type of signal output
from the COMPONENT VIDEO OUT jacks
on the player. See page 87 for more
information about the different types.
INTERLACE
PROGRESSIVE
Select this when you are
connected to a standard
(interlace format ) TV.
Select this when you have a
TV that can accept progressive
signals (NTSC only).
16:9 aspect ratio TV 4:3 aspect ratio TV
FULL
NORMAL
Select this when you can
change the aspect ratio on your
TV.
Select this when you cannot
change the aspect ratio on your
TV. Shows a 16:9 aspect ratio
signal with black bands on left
and right sides of the image,
and a 4:3 aspect ratio signal
with black bands on all sides
of the image.