Filter
Top Products
W
DTS
Selects the DTS signals to be output via the DIGITAL OUT
OPTICAL and COAXIAL connectors You cannot select
this item when you set “DIGITAL OUT” to “OFF
”
l
QFJ
when the player is connected to an audio
component lacking a built-in DTS decoder
l ON: when the player is connected to an audio
component having a built-in DTS decoder
If the player is connected to an audio component
lacking a built-in DTS decoder, do not set this
Otherwise, when you play the DTS sound track, a loud
noise will come out from the speakers, affecting your
ears or causing the speakers to be damaged
Note
Select the setting correctly Otherwise, no sound or a strange
sound will come out from the speakers, affecting your ears or
causing the speakers to be damaged
Controlling your TV or AV
Receiver (Amplifier) with
the Supplied Remote
ITi
If you adjust the remote signal, you can control your TV
or AV receiver (amplifier) with the supplied remote
Default setting is to control Sony TVs with the H mark
Number buttons
TV I/O
Hold down
TV
I/C!l,
and enter your
TV’s
or
AV
receiver’s manufacturer’s code (see the table) using the
number buttons. Then release
N
IK!l
Code numbers of controllable
Ns
or
AV receivers (amplifiers)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV or AV receiver (amplifier)
Notes
l If you enter a new code number, the code number previously
entered will be erased
l When you replace the batteries of the remote commander, the
code number reset to
01
(Sony) Reset the appropriate code
number
53