Filter
Top Products
General
How to restore Video settings Press on the remote control while in the Video menu (see page 102).
to _actol T settings
How to restore Audio settings Press on the remote control while in the Audio menu (see page 106)•
to _actory settings
Cannot cycle through the other Be sure the option is not set to (seepage 116).
video equipment connected to
the TV
Cannot operate menu Ifa menu option appears in gray, this indicates that the menu option is not
available.
Lost password In the password screen (see page 112), enter the following master password:
• The master password clears your previous password; it cannot be used to
temporarily unblock channels•
The iiINK STANDBY LED blinks when the signal froln an iiINK device is
being shown.
LED on the display unit isiii The POWER STANDBY LED (see page i8i lights up when the TV is iumed on.
If the LED blinks continuously, this may indicate the TV needs a service.
The TIMER LED (see page 18) indicates that the timer is set. When the timer is
set, this LED will remain lit even when the TV is turned off.
If the STANDBY LED blinks, disconnect the AC power cord and leave the TV for
three minutes to check that it stops blinking. If the LED does not stop blinking,
contact qualified Sony personnel•
The signal fi'om a selected If you have several i.LINK devices connected and operating at once, the TV may
iiINK device is not being not be able to display the signal fi'om the selected device. Turn the other i.LINK
displayed devices oil, and reselect the desired iilNK device.