Filter
Top Products
11
Using the Individual Setting menu
When you select there will be no personal pre-selection. lets you make your own
individual selection of themes, limiting the search to the marked ones.
1 Select
using 4 or $. Push to ” to enter.
The Individual Setting menu is displayed.
2 Select the item you wish to mark using 4 or $. Confirm by pressing OK.
Repeat step 2 for all items you wish to have in your list.
3 When you have finished the list, press ” to select
on the menu screen then press OK.
Using the Long Info menu
1 Select a future programme in the column programme list using 4 or $. Press OK.
The long info menu is displayed.
You wish to record the selected programme with your VCR
(only with Smartlink VCRs)
2 Select
using “ and press OK.
The information is transferred to the VCR connected to your TV set.
Setting up your VCR
3 Select VPS/PDC pushing repeatedly to “.
With this setting on, you have the guaranteed recording of the whole broadcast should
there be a change in the TV programme. This only works if the selected channel
broadcasts a VPS/PDC signal.
•
Select On or Off using OK.
4 Select Speed using $.
Select between standardplay (SP) or longplay (LP) mode. With longplay you can record
twice as much on a videotape. The picture quality, however, may suffer.
•
Select SP or LP using OK.
5 Select VCR Setup using $.
Select with which of the connected Smartlink-VCRs you wish to programme.
•
Select VCR 1 or 2 using OK.
To leave the menu
6 Select
using z. Press OK.
You are back in the last menu.
07 Tue
12:38
Address Mapping
The position of the addresses in the
OSDA is shown in the following diagram.
The position values of the DPW are set
to '0'.
If other values are set, the complete
combination will be scrolled.
Example:
if the DPWC is set to '63', the char-
Speed
Timer Prog
VPS/PDC
SP
VCR1
On
This channel has been set for a timer
First nextTView/EPG-Providers in Europe
SWISS TXT TPS / RINGIER nexTView
Tue 07. 04 .98
Speed
VCR Setup
VPS/PDC
SP
VCR1
On
Operation