Filter
Top Products
5
Installation
3. Connecting the TV
1 Connect your existing aerial lead to the socket marked ˘ on the rear of the TV set.
Connecting an aerial to your TV
Connecting an aerial and VCR to your TV
1 Connect your existing aerial lead to your VCR as shown.
2 Connect the VCR aerial lead from the RF OUT socket on the back of the VCR to the aerial socketon the back of the
TV as shown.
3 Connect the VCR set to the mains and switch on.
4 Insert a pre-recorded tape into the VCR and press the ‘PLAY‘ button.
L/G/S/IR/D/D/D
R/D
D/D
L/G
S/I
1
1
2
S
2
3
S
3
If you are not connecting
your TV to a VCR, please
connect the aerial lead (as
shown left) and proceed to
section ‘4.Switching on the
TV‘.
If you are connecting your
TV to a VCR please refer to
the section below.
The scart lead is optional. If it
can be used however, this
additional connection can
improve picture and sound
quality when in play mode.
L/G/S/IR/D/D/D
R/D
D/D
L/G
S/I
1
1
2
S
2
3
S
3
OUT
IN
AC IN
(scart lead -
not supplied)
(existing aerial lead)