Filter
Top Products
2-6 (E) Chapter 2 Preparations
2-2 Settings on the MAV-555
2-2-4 Settings for Changing File Times
When using the + and – keys to select files on the MAV-555, you can set the
amount of time before a file actually loads after key operation is completed.
For example, if the time is set to 0.5 seconds, a list of files registered on the
MAV-555 is shown on the superimposed monitor display while the + and –
keys are pressed repeatedly. The currently displayed file starts loading 0.5
seconds after you stop key operation (it takes approximately 1 second for the
file to load).
Make this setting in the FILE CHANGE TIME sub menu of MAV-555
Expansion menu item 320 MAVE-F555 CONTROL. However, the FILE
CHANGE TIME of the sub menu is the same for the time to cue-up after the
cut/jump operation with continuous key presses ends.
For MAV-555 Expansion menu settings, refer to the MAV-555 Operation Manual.
For how to select MAV-555 files from the editing panel, see Section 3-1-1, “File
Selection” (page 3-1).
2-2-5 Settings with the MAVE-D555
For details about controlling an external VTR with a MAVE-D555 connected
to the MAVE-F555, see page 3-40 of this operation manual.