Filter
Top Products
Chapter 1 Overview 1-11 (E)
0 Channel specification keys
V, A1, A2, A3, and A4 keys
Specifies the channel targeted for editing.
qa TRIM key
Use for trimming the IN and OUT points after
inserting or writing over cuts in the nonlinear (or
linear) editing mode.
qs Cut jump operation section
In nonlinear editing (or linear editing), these cue up
sequentially (“cut jump”) to a cut point in a file
subject to editing loaded on the port.
See Section 3-2-1, “Cut Jump Function” (page 3-11).
qd MARK IN key and MARK OUT key
In editing operations, these specify an IN point or
OUT point.
qf MARK SPLIT key
Use for split editing.
qg SHIFT key
This key is used in combination with other keys,
for specific operations.
qh EXECUTE/REC (execute/recording) key
In file operations or editing operations, press this to
confirm an operation.
When editing, pressing the EXECUTE/REC key
ends editing and the point when the key is pressed
is set as the OUT point.
qj REPLAY/PREVIEW key
Press the PREVIEW key to view the content of the
previous edit on the monitor before executing the
next edit. Press REPLAY (SHIFT+PREVIEW) key
to view the edit results after the edit is completed.