Filter
Top Products
Chapter 2 Preparations 2-5 (E)
2-2 Settings on the MAV-555
2-2-1 Operation Mode Setting
It is necessary to set the MAV-555 operation mode according on the
application of the system configuration. Carry out the setting in the MAV-555
basic menu item 019 “SYSTEM OPERATE CONFIG.”
• When conducting editing operations with the MAVE-F555 in combination
with a MAVE-D555 or BVE-series editor (see Chapter 3 of this operation
manual), switch the MAV-555 operation mode to BVE mode.
• When using multiple MAVE-F555 units connected to a single MAV-555
through the TO MAV (PARALLEL I/O) terminal, set the MAV-555 to
PANEL mode if you simply want to perform file assignment and recording/
playback control (see Chapter 4 in this manual).
For details of the MAV-555 basic menu setting operations and the operation modes,
refer to the MAV-555 Operation Manual.
2-2-2 Port Settings
Depending on the connection configuration of the MAVE-F555 and external
devices, set MAV-555 Expansion menu item 324, “MAVE-F555 PORT” as
required. Making the port setting requires you to understand the MAVE-F555
recorder selection function.
For details of the recorder selection function, see Section 3-4, “Recorder Selection
Function” (page 3-63). For the MAV-555 port setting, see Section 3-4-1, “Settings on
the MAV-555” (page 3-63).
Note
When multiple editing panels are connected to a single MAV-555 through the
TO MAV (PARALLEL I/O) terminal, there is no need to make port settings
on the MAV-555 as long as the editing panel is used simply to make file
assignments or control recording/playback (see chapter 4).
2-2-3 Settings for Superimposed Indications
Various messages appear superimposed on the monitor screen connected to the
MONITOR OUT connector of the MAV-555, reflecting operations from the
MAVE-F555.
Rp] R [MAV No0003
Ch i cago*Or l and
(Example display)
You can adjust the position of the superimposed indications using “V
POSITION” in the MAV-555 Expansion menu item 323 “LINEAR EDIT
MESSAGE.”
Displayed message disappear after a preset time, and you can set this time
using “FADE TIME” in the MAV-555 Expansion menu item 323 “LINEAR
EDIT MESSAGE.”
For details of MAV-555 Expansion menu setting operations, refer to the MAV-555
Operation Manual.