Filter
Top Products
3-32 (E) Chapter 3 Operations for Linear/Nonlinear Editing
3-2 Operations for Nonlinear Editing (Operations in Cut Units)
Notes
• Editing can be performed without specifying an OUT point with the MARK
OUT key on the MAVE-F555. Press the EXECUTE/REC key and when the
desired OUT point appears press the ALL STOP key on the MAVE-D555.
The stop point is specified as the OUT point.
• After executing the cut overwriting, as the recorder file is replaced by the
editing result file, the monitor screen goes temporarily blank.
• When you select only specific channels for overwriting with the cut in step 6
above, then the result is as shown in the following figure.
Player
Specified section
IN OUT
Recorder
IN point
V
A1
A2
A3
A4
Result of editing
when A1 and A2 are specified
For details of the holding period for the player and recorder IN point and OUT point,
see Section 3-2-12, “IN Point and OUT Point Holding Periods” (page 3-54).