Filter
Top Products
3-24 (E) Chapter 3 Operations for Linear/Nonlinear Editing
3-2 Operations for Nonlinear Editing (Operations in Cut Units)
Specifying a section on the recorder, and inserting at a specified
position on the recorder
To specify the section for a cut to insert at a specified position within the same
file on the recorder, use the following procedure.
REDO
UNDO
V A1 A2 A3 A4
TRIM
MARK
SPLIT
MARK OUTMARK IN
REPLAY
PREVIEW
EXECUTE/
REC
SHIFT
R
STORE
+
-
P1 P2 BG
PORT/FILE ASSIGN
1 Press the [ ] key, and select INSERT mode.
2 Select the recorder port.
3 Use the MAVE-D555 or BVE-series editor jog dial to search for the IN
point.
4 Holding down the SHIFT key on the MAVE-F555, press the MARK IN
key.
This specifies the IN point for the source for the cut to be inserted.
5 The same as the IN point, use the MAVE-D555 or BVE-series editor jog
dial to search for the OUT point.
6 Holding down the SHIFT key on the MAVE-F555, press the MARK OUT
key.
This specifies the OUT point for the source for the cut to be inserted.
7 Now continue from step 8 of the procedure under “Specifying a section on
the player, and inserting at a specified position on the recorder” (page 3-21).
6
4
1
2
4,6