Filter
Top Products
Chapter 3 Operations for Linear/Nonlinear Editing 3-11 (E)
3-2-1 Cut Jump Function (Cueing Up to a Cut Point)
You can cue up to successive cut points in the file subject to editing loaded on
the MAV-555 port. This is termed a “Cut jump.”
Note
When the MAV-555 is turned off before saving the cut point information, the
information is cleared.
For details, see Section 3-2-2 "Save and Recall Cut Point Information" (page 3-14).
Cut Jumping on a Recorder Port
REDO
UNDO
V A1 A2 A3 A4
TRIM
MARK
SPLIT
MARK OUTMARK IN
To perform a cut jump, use the following procedure.
1 Using the channel specification keys (V, A1, A2, A3, and A4), select the
channel on which you want to search for the cut point.
Press the key corresponding to the channel on which you want to search
for the cut point, turning on the indicator above the key. You can select
more than one channel.
1
2