Filter
Top Products
About this Operation Manual 7 (E)
Chapter 2 Preparations
2-3 (E)
2-1-3 Connecting the MAVE-F555 and MAV-555
Connection with the TO MAV connector
To fully exploit the nonlinear editing, background operation, recorder selection
function, and other functions of the MAVE-F555, connect the TO MAV
connector of the MAVE-F555 to the REMOTE SPARE connector of the
MAV-555. Connections of other devices to the MAV-555 are the same as
when the MAV-555 operation mode is set to BVE mode.
IN1
(
EDITOR R
)
IN2
(
EDITOR P
)
POWER
OUT1
(
MAV P1
)
TO MAV
OUT2
(
VTR
)
1
TO MAV
(
PARALLEL I/O
)
DC IN
(
12V
)
2
D555 I/FAV SEL OUT
ANALOG IN1
ANALOG IN2
BKMA-570
MAV-555
MAVE-F555
BVE-600
MXP-29
VTR
AV SELECTOR
ANALOG OUT2
ANALOG OUT1
VIDEO IN COMPOSITE R2
VIDEO OUT COMPOSITE P2
REMOTE IN4(P2)
P2 REMOTE
R REMOTE
P1 REMOTE
R MIC /LINE IN
P1 MIC /LINE IN
LINE OUT
P2 MIC /LINE IN
REMOTE IN2(P1)
REMOTE IN
REMOTE SPARE
VIDEO OUT
COMPOSITE P1
VIDEO IN
COMPOSITE R1
ANALOG
COMPOSITE IN
ANALOG
COMPOSITE OUT
ANALOG
AUDIO OUT
RECORDER MONITOR
COMPOSITE VIDEO IN P1
VIDEO OUT
MIXER REMOTE EDITOR
ANALOG
AUDIO IN
MONITOR
OUT
For details of RS-422 connections between the MAVE-F555 and other devices, see
Section 3-4, “Recorder Selection Function” (page 3-63).
BVM-series or other
video monitor
How to use this manual
Procedure descriptions
Numerals attached to buttons and switches in illustrations indicate the
corresponding steps of a procedure. They are also used to indicate switches
used in an operation, indicators which must be checked, information
superimposed on the monitor screen (the MONITOR OUT output of the
MAV-555), and so on.
Cross-references to related information in this manual or other documentation
are in italics, and show the item to be referred to and the page number. When
the related information is in a manual other than this manual, the cross-
reference gives the title of the other manual.
Chapter 3 Operations for Linear/Nonlinear Editing
3-11 (E)
3-2-1 Cut Jump Function (Cueing Up to a Cut Point)
You can cue up to successive cut points in the file subject to editing loaded on
the MAV-555 port. This is termed a “Cut jump.”
Note
When the MAV-555 is turned off before saving the cut point information, the
information is cleared.
For details, see Section 3-2-2 "Save and Recall Cut Point Information" (page 3-14).
Cut Jumping on a Recorder Port
REDO
UNDO
V A1 A2 A3 A4
TRIM
MARK
SPLIT
MARK OUTMARK IN
To perform a cut jump, use the following procedure.
1
Using the channel specification keys (V, A1, A2, A3, and A4), select the
channel on which you want to search for the cut point.
Press the key corresponding to the channel on which you want to search
for the cut point, turning on the indicator above the key. You can select
more than one channel.
1
2
Example description
Switches and other controls
used in the step described
below
Step number within a procedure
Results of an operation or
other related information
Description of the operation
Cross-reference