Filter
Top Products
3-26 (E) Chapter 3 Operations for Linear/Nonlinear Editing
3-2 Operations for Nonlinear Editing (Operations in Cut Units)
5 Just like the IN point, use the MAVE-D555 or BVE-series editor jog dial
to search for the ending point (OUT point) of the original cut for
switching.
6 Press the MARK OUT key on the MAVE-F555.
The time data of the OUT point appears on the monitor screen.
7 Select the recorder port.
8 Use the MAVE-D555 or BVE-series editor jog dial to search for the
starting point (IN point) where the switch cut is to be inserted will start.
9 Press the MARK IN key on the MAVE-F555.
The time data of the IN point appears on the monitor screen.
10
Use the MAVE-D555 or BVE-series editor jog dial to search for the
ending point (OUT point) where the switch cut to be inserted will end.
11
Press the MARK OUT key on the MAVE-F555.
The time data of the OUT point appears on the monitor screen.
12
Using the channel specification keys (V, A1, A2, A3, and A4), select the
channel(s) where you will make the replacement.
• Press the key(s) corresponding to the channel(s) in which you want to
make the replacement, turning on the indicator(s) above the key(s).
• If you select only specific channels for the cut replacement, to make the
lengths of all channels the same, BLACK/MUTING material is added as
appropriate at the end of the short channels.
13
To execute the cut replacement, press the EXECUTE/REC key.
• This carries out the replacement, and “EDITED” appears on the monitor
screen.
• The recorder file is replaced by the editing result file (the file after
making the replacement), and the unit cues up to the OUT point of the
replaced section.
Notes
• After executing the cut replacement, as the recorder file is replaced by the
editing result file, the monitor screen goes temporarily blank.
For details of the holding period for the player and recorder IN point and OUT
point, see Section 3-2-12, “IN Point and OUT Point Holding Periods” (page 3-54).
• Editing can be performed without specifying an OUT point with the MARK
OUT key on the MAVE-F555. Press the EXECUTE/REC key and when the
desired OUT point appears press the ALL STOP key on the MAVE-D555.
The stop point is specified as the OUT point.
• With an external VTR selected as the Player, a cut cannot be replaced. In this
case, the OUT point specified on the Recorder port is disabled, and the cut is
inserted at the specified IN point. (The result is the same as inserting a cut.)