Filter
Top Products
14
GB
When you select the input
source to the amplifier
1 Turn the Jog dial to select
“AMP,” then press the Jog
dial.
Note
If you have changed the name of
the amplifier (page 26), that name is
displayed.
2 Turn the Jog dial to select
the desired component.
The selection order is as
follows.
Notes
•If the preset amplifier does not
have an input select function, or
you have not “learned” any
functions to the buttons (page 15),
no names are displayed.
•The names and numbers of input
sources vary depending on the
component’s code number,
“learned” functions, or if you
changed the names using the
NAME function (page 26).
3 Press the Jog dial.
appears in the display. The
input source is set, and “AMP”
appears in the display again.
Note
If the input select does not function
properly, you can setup the
Commander using the Learning
function (page 15).
Tip
It is convenient if you program
frequently used input sources to the
Number buttons or Colour buttons
using the Learning function (page 15).
Operating Your Components
with the Remote Commander
(continued)
Note on buttons that have
already “learned” remote
control signals
If another signal has already been
programmed on that button using
the Learning function (page 15),
that “learned” signal will work
even after you set the component
code number. To use it as a preset
function button, first erase its
“learned” signal (page 21).
When you use a double cassette
deck
1 If the remote control for your
deck has a Deck A/B select
control, the (recall) button on
your Commander has the
corresponding function.
2 If you cannot select Deck A/B
with the (recall) button, first
set the number code for either
one of the decks, and
•set the function controls for
the other deck to other free
buttons (for example, the
Number buttons) using the
Learning function (page 15),
or
•assign the other deck to
another Setting position
number (page 8).
TAPE
VIDEO2VIDEO1
PHONO
INPUT
AUX
TUNER
DVD CDTV