Filter
Top Products
26
GB
Changing the Name
of the Component
(NAME)
You can change the name of the
component to operate. This is
convenient when you are using
more than one of the same
component.
You can write up to six characters
for the component name.
Changing the Component
Selection Order (MOVE)
(continued)
The component selection order
is changed as follows.
If you want to move the
position again, repeat Steps 3
and 4.
5 Select “EXIT,” then press
the Jog dial to finish setting.
To cancel setup
Press SET.
Note
If you have set the code number “000”
for a component (page 10), it is not
displayed.
Tip
You can also skip an unused
component by setting its code number
to “000” (page 10).
Tip
You can also press b/B instead of
turning the Jog dial to the left/right
(except for when you select a character
to write a name).
You can also press OK instead of
pressing the Jog dial.
VCR AMP TV SAT
DVD
TAPE MD CD
5
1,7
Jog
dial