Filter
Top Products
16
GB
3 Turn the Jog dial to select
the Setting position number
(“S-1” to “S-8”) of the
component you want to set
up. Then press the Jog dial.
The component name flashes
in the display.
Note
If you have changed the name of
the component (page 26), that name
is displayed.
4 Press the button on the
Commander you want to
“teach.”
The component name stops
flashing, and “LEARN” flashes
rapidly in the display
(Learning function standby).
If another signal has already
been “learned” by that
button
“NG” flashes twice, and the
component name flashes again.
Either “teach” to another free
button, or erase the already
“learned” function (page 21)
and start over from the
beginning.
Tip
You can also press b/B instead of
turning the Jog dial to the left/right.
You can also press OK instead of
pressing the Jog dial.
Example: To program the N
(Play) signal of your component
to the VCR N (Play) button of
the Commander
You can “teach” to “AMP” only at
“S-8.” See also page 18.
1 Place the RM-VZ950T head
to head with your
component’s remote
control.
2 Press SET, turn the Jog dial
to select “LEARN,” then
press the Jog dial.
The Setting position number
flashes, and the component
name appears in the display.
The Commander changes to
the LEARN mode.
Note
If you have changed the name of
the component (page 26), that name
is displayed.
Operating Non-Preset
Components
— Learning Function (continued)
Remote control for
your component
RM-VZ950T
about 5 – 10 cm
(2 – 4 inches) away
-1S
ARNLE
VT
-3S
R
ARNLE
CV
-3S
R
ARNLE
CV