Filter
Top Products
7
GB
About the LCD display
The LCD (Liquid Crystal Display)
displays the component in
operation or the current status of
the Commander as shown below.
It also has a backlight that lights
up when you turn or push the Jog
dial during component operations
(does not light up at SET modes).
When a remote control signal is
sent, appears in the display.
Example: At normal mode
Example: At SET mode
* You can control up to 8 components,
each of which are preset at Setting
position numbers “S-1” to “S-8.”
Note
At normal conditions, the LCD display
shows the last selected component
name. When the batteries are low of
charge, “BATT” appears in the display
after you press a control button.
How to use the Jog dial
The Jog dial can be used to
perform various operations at the
setup procedure, as well as
selecting the components to
operate.
Example: At normal mode
1 Turn the Jog dial to select the
component you want to
operate.
2 Press the button for the desired
function.
Example: At SET mode
1 Turn the Jog dial to select the
Setting position number (“S-1”
to “S-8”).
2 Press to enter.
The component name flashes in
the display.
Tip
You can also press b/B instead of
turning the Jog dial to the left/right
(except for when you select a character
at the NAME mode).
You can also press OK instead of
pressing the Jog dial.
Current Component
Remote control signal indicator
-1S
¢
ESETPR
VT¢1
Remote control signal indicator
Component Component
code number
Setting mode
Setting position number*
RCV
-1S
ESETPR
VT