Filter
Top Products
15
GB
Controlling the volume
To control the volume of an
audio component (CD, MD, TAPE)
Press 2 +/– to control the
volume, and to mute on the
amplifier.
Example
When you press 2 +/– at “CD,”
you can control the volume of the
amplifier.
You can change this setting also
(page 15).
To control the volume of a
visual component (SAT, VCR,
DVD)
Press 2 +/– to control the
volume, and to mute on the TV.
Example
When you press 2 +/– at “VCR,”
you can control the volume of the
TV.
You can change this setting also
(page 15).
Note
If you have programmed any signal on
the 2 +/– or
button for “TV” or
“AMP” using the Learning function
(page 15), that signal will not be
transmitted when you control other
components. To use “learned” signals,
you need to program the 2 +/– or
buttons for each component using the
Learning function.
Operating Non-Preset
Components
— Learning Function
To operate non-preset components
or functions, use the following
Learning procedure to “teach” any
of the programmable buttons to
operate the functions of another
remote control. You can also use
the Learning function to change
the signals of individual buttons
after setting the component code
number.
It is recommended that you make
a note of the “learned” function
controls.
Note
Some specific remote control signals
may not be “learned.”
Programming a component
signal
Continued
2
Jog
dial