Filter
Top Products
6 Getting Started
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer’s code
number.
1 Set TV / VIDEO at the top of the remote commander to TV .
2 Hold down u, and enter your TV’s code number(s) using the
programme number buttons. Then release u.
Now you can use the following TV control buttons to control your TV:
u (on/standby), TV/VIDEO, programme number buttons, PROG +/–,
VOL +/–, and WIDE with some TV.
Tip
• If you set your TV’s code number correctly while the TV is turned on, the TV turns
off automatically.
Step 2 : Setting up the remote commander (continued)
Notes
• The TV/VIDEO button selects an input source of the TV from aerial in or line in.
The button does not control this VCR.
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not mix different types of batteries.