Filter
Top Products
Setting Up the Projection TV
33
Completing i.LINK
Setup
Before you can use an i.LINK device with the projection TV, you need
to register the device as follows.
1 After you’ve connected the cables (as described on page 31), first
turn on the projection TV, and then turn on the i.LINK device(s).
The following screen automatically appears.
To add the i.LINK device, highlight
Add and press .
2 If you selected Add in step 1, and the device requires an analog
video connection (see the device’s instruction manual), the
following screen appears.
3 Move the joystick V and v to highlight the video input (VIDEO 1-4)
that connects the i.LINK device to the projection TV. If you don’t
need an analog video connection, select
None. Then press .
A confirmation screen appears, which indicates the i.LINK device
name and video input. The device is now available in the i.LINK
Control Panel (see page 48).
For more information
❑
To change the setup of the i.LINK device, use the Setup menu.
For details, see page 65.
❑ For information on using the i.LINK Control Panel, see page 48.
❑ For general information about i.LINK, see page 73.
✍ If you select Cancel, the i.LINK device is set up as “hidden” and it does
not appear in the i.LINK Control Panel. To see the device in the i.LINK
Control Panel, change the i.LINK Setup option from Hide to Show in the
Setup menu (see page 65).
✍ Depending on the i.LINK device you are setting up, this screen may not be
displayed. In this case, the device’s video input will be displayed as N/A.