Filter
Top Products
Other Information
68
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to
control with the projection TV’s remote control, use the following
procedures to program the remote control.
1 Check the list of the “Manufacturer’s Codes” listed on page 70,
and find the three-digit code number for the manufacturer for
your equipment. (If more than one code number is listed, start
with the number listed first.)
2 Open the panel on the remote control. Then move the slide
switch to one of the four positions (AV1, AV2, AV3, DVD).
3 Press CODE SET.
4 Close the panel on the remote control and enter the three-digit
manufacturer’s code number.
5 Press ENTER.
6 To check if the code number works, aim the projection TV’s
remote control at the equipment and press the green
POWER
button that corresponds with that equipment. If it responds, you
are done. If not, try using another code listed for that
manufacturer.
Sony
Equipment
Switch Position
on Remote Control
Programmable
Code Number
Beta, ED Beta VCRs AV1 303
8 mm VCR AV2 302
VHS VCR AV3 301
DVD Player DVD 751
✍ The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
✍ You must perform step 4 within 10 seconds of step 3.
3
2
5
4