Filter
Top Products
Additional information
36
From time to time dust particles or condensation may get trapped between the glass panel and the TV screen. These instructions will
guide you through the steps required to both remove and re-fit the glass panel safely.
Removing the glass panel
NEVER attempt to remove the glass panel on your own - for safety reasons Sony recommends that two people carry out the
following procedure at all times.
Support the bottom of the glass
panel as shown AT ALL TIMES.
Whilst pushing the release clip,
slide the glass panel up.
Push the clips located on the
underside of the TV, as shown, to
release the glass panel.
Trinitron
Re-fitting the glass panel
NEVER attempt to re-fit the glass panel on your own - for safety reasons Sony recommends that two people carry out the following
procedure at all times.
1
Safety Note
The glass panel supplied complies with all relevant safety regulations. However, should the glass become damaged at
any time, it is strongly recommended that a replacement is obtained from an authorised Sony dealer.
1
Lift the glass, and move toward
the TV.
2
3
Tilt the glass panel forwards at the
top to engage all the locating pins,
then push forward firmly to secure.
4
2 3
654
Supporting the glass panel, tilt it
away from the TV.
Carefully remove the glass panel
and place it safely in an upright
position. To avoid injury or damage,
do not leave it on the floor.
Clean both sides of the glass and the
TV screen. Use a soft, damp, lint free
cloth. Do not use any chemical
solutions or abrasive cleaners.
CAUTION
Before removing your hands check that you are unable to move the glass.
When correctly fitted, the plastic rib shown in the drawing below should not be
visible.
Insert the bottom locating pins of
the glass panel into the keyhole
slots on the TV.
While still maintaining forward
pressure to the bottom of the glass,
carefully slide the glass down until it
locks.
Locating pin
Plastic rib
NX31-36.fm Page 36 Wednesday, September 5, 2001 9:39 AM