Filter
Top Products
PART 1
•
English
15
2. Use the UP/DOWN keys on your Remote control, select the language in which
you want your menu to be displayed and press OK. The screen of the menu will
now change to the language of your choice, and the menu option “Channel Set-
Up” will appear on your screen.
3. You will see the “Channel Set-Up” screen with different parameters. The pre-set
values are correct for the ASTRA satellite. We strongly advise you to NOT
change any of the settings before you are sure that your dish is aligned correctly.
4. You will see two signal bar fields at the right lower part of your screen, showing
Signal strength and signal quality.
5. Leave the satellite receiver in this menu and start with the alignment of your
dish. The ASTRA satellite is located at 19.2° East. Find with a compass what is
North and South, keep the Compass in your hand and turn your position until
South is in front of your face. Now turn 19 Degrees to he left, this is roughly the-
position where the Astra satellite must be found.
6. Now slowly move your dish to the left or to the right , make small steps to allow
the (green) signal bars to display the signal level. Note that you will not see any
green bars until you have aimed your dish to the ASTRA satellite correctly.
If you can not find the signal by turning Left or Right, then increase or decrease
the vertical angle of you dish and again turn Left and Right. Repeat these steps
until you see the Green signal bars appearing.
7. Once you see the bars, try to optimize the Level and Quality bars my making
very small movements with the dish in Left, Right, Upper or Lower direction.
Once you are convinced that you have the optimal signal strength, firmly fix you
dish on that position.
8. Now you are ready to search the satellite and scan the available channels, you
have different options to scan, we recommend you to the keep the settings in
the menu as they are. Just press the RED (Automatic) button on your remote
control to start the automatic scan. All channels will be found automatically, and
once the search is completed the found channels will be stored in a logical
order.