Filter
Top Products
PART 1
•
English
25
Connection Settings: You can set the connection settings to your personal
preferences. Check your TV and VCR user manuals for the correct settings. You
can change your Connection settings by applying the following steps:
1.Select “Connection” and press OK or the Right button.
TV Mode: Press OK or the Right button and set your TV mode to
“Multi”, “PAL” or “NTSC”.
Video Output: Press OK or the Right button and set your Video
mode to “CVBS” (Composite video) or “RGB” (preferred option if
your TV set is compatible with it).
TV mode: Press OK or the Right button and set your screen mode
to “4 : 3” , “4 : 3 Letterbox”, or “16 : 9” format. This depends on
the format of your TV.
Audio Output : Press OK or the Right button and set your audio output
to “Stereo”, “Left” or “Right” (left or Right is for mono TV sets)
S/PDIF Output: Press OK or the Right button and activate your
S/PDIF output on the back of your receiver, so you can connect it to
a digital Audio amplifier using an coaxial cable. If you have connected
your digital amplifier, set the SPDIF output to: “Enabled”.
VCR Output: Press OK or the Right button and set the scart
output to “Automatic” or “Terminal”. If set to “Terminal”, the VCR
scart signal is not automatically looped through.
RF modulator: Press OK or the Right button and set the UHF
mode to “PAL B/G”, “PAL I” or “PAL D/K”. If the TV set is
connected using a coaxial (RF) cable, you must select RF modulator
type here. The RF modulator type affects the channel audio.
(Select PAL I for UK , Pal B/G for use in Central Europe).