Filter
Top Products
PART 1
•
English
33
5.1.4.3.1 Positioner Set-up (if you are using a Motorised positioner
with DiSEqC1.2)
If you are using a motorised positioner with DiSEqC 1.2 you will have to set the positions
of the satellites you want to scan. This function is available only if in the “LNB Set-up”
menu and the LNB Dish field is set to “Moved”. (As described in “LNB Set-up” (Described
in section 5.1.4.2).
Before you start:
1. Make sure that your installer has set the centre position of your dish.
2. Make sure that the mechanical limits of your motor are set, so that no damage
can be done to your dish by moving it too far to the East/West.
3. Make sure you set the highest Symbol Rate (Ksymbols/sec) for your chosen
transponder (TP). The Signal level and Quality indicator will help you set up the
best dish position possible.
4. Use your UP/DOWN buttons to select the “Dish Position" field in the “Channel
Set-up” menu. ( Note that the LNB dish in the LNB setup menu is set to
“Motorized”.)
5. Press the OK button and the “Positioner Set-up” Menu will be displayed.
6. Start setting the position of the selected satellite.
7. Use your UP/DOWN buttons to go to field “Centre” and use your Left/Right
buttons to put the centre field to “On”.
8. Press OK, and your dish will move to the centre position. It takes your dish
maximum 30 seconds to move to its central position.
9. To know in which direction you will need to move your dish, you will need to
know the position of the satellite you want it to position to.
10. If correctly installed, your installer has set the centre position of your dish to
the “true” South if in the Northern hemisphere and to “true” North if in the
Southern Hemisphere.