Filter
Top Products
OPERATION INSTRUCTION continued
• Date: Select either "Everyday", "Sun", "Mon", "Tue", "Wed", "Thu", "Fri", "Sat"
and "Peak", when "Peak" time selected, the device will not use the stand-by
function.
• Period 1 and Period 2: Select start time and end time.
Motion Mode: "On, Off" are the 2 different status settings to enable and disable this func-
tion respectively. Using the cursor to select and press [Enter] to confirm this function.
A-4 Motion Detection Setting:
Highlight and select Motion Detection, then press [Enter] for this selection, the sub-menu will
shown (as below), then select the required area.
Effective Region: Use the cursor to select Settings and press [Enter] to confirm this function.
Then there will be a region setting screen with full of square grid (as picture shown below),
press [Setting] to get the detect area as full screen (all the grid squares will turn a light
green square as selected) re-press [Setting] to cancel the selected areas (all grid squares
will turn back to clear, and there will be purple flashing cursor right in the centre of screen
for selection).
• Using the directional key to move purple cursor for selection. When the grid block
being selected (press [Enter] to select), the block will turn light green.
• Cancel with re-press [Enter] key in the block.
• When there are objects moving in the selected region, the block will turn yellow and
flashing. (This will activate the recording, if there had been pre-set already).
• Alarm: "On, Off" 2 different status settings. Using the cursor to select and press [Enter]
to confirm this function.
GENERAL SETTINGS
Record Settings
Timer Record
Motion Detection
Alarm Record
Channels
Housings
Network
Language
Exit
Motion Detection
Channel Effective Alarm
Region
1 Settings On
2 Settings On
3 Settings Off
4 Settings Off
Return