Filter
Top Products
OPERATION INSTRUCTION continued
• Use the directional key to move small yellow block selection. When 4 points of yellow
block are produced there will be q region wet up for the coverage setting area.
Time insert: "On, Off" are the 2 different status settings. Use the cursor to select and press
[Enter] to confirm this function. While "On" selected, a system clock will be shown while
recording.
A-7 Housing Setting:
Highlight and select Housings, then press [Enter]for the selection, the sub-menu will shown
(as below), then select the required area.
Protocol: Using the cursor to select and press [Enter]to confirm difference protocol
(pelco-d/p/02-15 etc.);
BaudRate: Using the cursor to select and press [Enter] select difference rate at
1200/2400/4800/9600;
No: Using the cursor to select and press [Enter] select difference housing number at
(01~63).
A-8 Network Setting:
Highlight and select Network, then press [Enter] for this selection, the sub-menu will be
shown (as below), then select the required area.
• IP Address: Use the cursor to select and press [Enter]to enter the IP address.
• Subnet mask: Use the cursor to select and press [Enter]to enter the subnet mask at
current location.
• Default Gateway: Use the cursor to select and press [Enter] select default gateway
according to current IP address.
• Transport protocol: Use the cursor to select and press [Enter] select.
A-9 Language Setting:
Make sure that English is the default setting.
GENERAL SETTINGS
Record Settings
Timer Record
Motion Detection
Alarm Record
Channels
Housings
Network
Language
Exit
Housing Settings
Channel Protocol BaudRate No.
1 pelco-d 1200 01
2 pelco-p 2400 10
3 enkel 4800 25
4 ccr-20g 9600 63
Return
GENERAL SETTINGS
Record Settings
Timer Record
Motion Detection
Alarm Record
Channels
Housings
Network
Language
Exit
Network Settings
IP Address: 029, 010, 001,100
Subnet mask: 255,255,255,000
Default gateway: 029,010,001,254
Transport protocol: TCP/IP
Return