SVAT Electronics CVDVR900 DVR User Manual


 
SYSTEM START-UP/SHUT DOWN
1. System Start up
Plug in your AC power, turn on the main unit, the red light will turn on while the system
boots up.
The system will be in standby mode. Press the [ON/OFF]button in front panel or remote
control, the red light will turn off, then the monitor will be activated to show as
4-channel windows status. There will be channel numbers shown to indicate each input
signal. Also, the top of screen will show the system time, number of hard disk and CF
card status (if applicable) shown in the center of the screen (there would be an alert
warning for no hard-disk installed), all of the information will be shown on the screen for
5~6 seconds. There will be a count down from 100 to 0 seconds (shown in red color
font). The system will be locked up after the count down reaches 0 seconds.
Notice: If the device is being set for timer record function, there is no need for standby
status after the system turns on, the system will go to multi-channel screen.
2. System Login
While the system is in lock-in status, press the [Login/Logoff] button in the front panel or
remote control, then the screen will have pop-up window appear stating
"Unit ID: *****, Unit ID : 000". Select the desired unit ID. "Password required: " then key in
your login password to enter into the system (The DVR will accept User password or
Administrator password).
1. After the user password is keyed in correctly, the message "USER PASSWORD
CORRECT" will be shown. Then the user can enter into restricted functional/feature
level functions with the device. (default password is : 00000000)
2. After the Administrator password is keyed in correctly a message "ADMIN
PASSWORD CORRECT" will appear, then the administrator can enter into all
functional/feature levels with the device. (default password is : 88888888)
Remark: There will be a difference between administrator and user level authorizations:
1. User can only playback all existing files, however, they can not stop the recording,
or access record setup. While the administrator can access all setup features.
2. After the password key in correctly, the count down timing (shown in top right
corner) will change from red to green color, this indicates that the user can access
different operations. There will be a 100 seconds operation time allowance after
each key-in button is pressed before system locked. The user will be required to re-
enter their password to returnto normal operation level once the "LOCK" indicator
shown in top right corner;
3. The user must key-in unit ID and password to enter into the operation system while in
LOCK status.
3. System Logoff
Press [Login/Logoff] button in the front panel or remote control after the record stop, the
system will go into standby mode.
Remark: Please make sure the system status is in standby mode before powering off. Please
do not power off the machine while it is in recording or playback system setting.