Filter
Top Products
OPERATION INSTRUCTION continued
A-5 Alarm Record Setting:
Highlight and select Alarm Record, then press [Enter] for this selection, the sub-menu will
shown (as below), then select the required area.
Alarm: "On, Off" are the 2 different status settings available. Use the cursor to select
and press [Enter] to confirm this function. While "On" is selected, there will be 16
different task settings for timer setup in each channel (8 different day types, and
2 different period settings available for each type):
• Date: Select either "Everyday", "Sun", "Mon", "Tue", "Wed", "Thu", "Fri", "Sat" and "Peak".
When "Peak" time is selected, the device does not have the stand-by function.
• Period 1 and Period 2: Available to select the start time and end time.
In_Mode: "Open, Close" are the 2 different input modes for alarm signal input. When the
alarm system is set to the "Close" option, when open signal starts, the alarm signal is
produced. The input mode in here should be set as "Open".
Alarm_Delay: Key in the number key to setup the time delay (range from 0 to 300 seconds)
for alarm recording (default setting as 10 seconds).
Out_Delay: Key in the number key to setup the time delay (range from 0 to 300 seconds)
for alarm output (default setting as 10 seconds).
Keep_Delay: Key in the number key to setup time delay (range from 0 to 300 seconds) for
alarm warning signal (default setting as 10 seconds).
For example: If an alarm is produced at 23:30:50 the device should start the recording
from time 23:30:40 since the system per-recording time was set as 10 seconds. The
system will release the alarm warning signal. Whole recording depends on the alarm
time, per-recording alarm time and alarm warning signal to perform recording
Multi_Ch_Rec: "On, Off" are the 2 different status settings available. Use the cursor to select
and press [Enter] to confirm this function. While "On" is selected, there will be 4 multiple
channels interface display as shown below:
GENERAL SETTINGS
Record Settings
Timer Record
Motion Detection
Alarm Record
Channels
Housings
Network
Language
Exit
Alarm Record Settings
Ch Alarm In_Mode
1 On Close Alarm_Delay: 005s
2 Off Open Out_Delay: 005s
3 On Open Keep_Delay: 005s
4 Off Open Multi_Ch_Rec: On
Multi_Ch_Output: On
Return
Channel 1 Alarm Record Settings
Date Period 1 Period 2
Everyday 08:00-12:00 14:00-18:00
Mon 08:00-12:00 14:00-18:00
Tue 08:00-12:00 14:00-18:00
Wed 08:00-12:00 14:00-18:00
Thurs 08:00-12:00 14:00-18:00
Fri 08:00-12:00 14:00-18:00
Sat 08:00-12:00 14:00-18:00
Peak 08:00-12:00 14:00-18:00
Return