Filter
Top Products
4 Administrator Settings
87
4.7 Security
Security contains the settings:
Encryption
Encryption Mode
Passwords
4.7.1 Encryption
(Country specific)
Auto
The system will try to set up calls using encryption.
Point to point calls: If the far end system supports encryption (AES or DES), the
call will be encrypted. If not, the call will proceed without encryption.
MultiSite calls: In order to have encrypted MultiSite calls, all sites must support
encryption. The padlock symbol will indicate encryption mode (AES or DES). If
there is a mix of AES and DES encryption, only the symbol for DES encryption
(single padlock) will be displayed.
IP MultiSite calls: Sites supporting encryption will be encrypted and sites not
supporting encryption will not be encrypted. The padlock symbol will be shown
on the MultiSite if all sites support encryption. The padlock symbol will be shown
on the site connected to the MultiSite if this connection to the MultiSite is
encrypted.
If the far end supports encryption, the systems will initiate encryption after the
call is connected (an ‘open padlock’ symbol will be displayed). When encryption
has been established, a ‘closed padlock’ symbol will be displayed.