Filter
Top Products
SECTION 9 : MONITOR AND OTHER CAPABILITIES
(3) Auto Input monitor
This causes the inputs whose corresponding tracks are
When you rotate the SHUTTLE knob for reel rocking to
record enabled to be sent directly to the same numbered
locate specific points on the tape, what you hear depends
outputs whenever the transport goes into any other modes on whether the shuttle monitor mode is activated or not, as
than play.
shown in the table below.
f Press INSERT and the associated LED will light
solidly to show that the auto input mode is entered.
NOTES
As discussed above, if fhe DA-38 is not remote
controlled, the INSERT key switches on or off not
only the auto input monitor functfon but a/so the
inser? monitor function.
l When the /NSERT LED is /it:
Both the insert and the auto input monitor modes
are activated.
l When the INSERT LED is turned off :
Both the inserl and the auto input monitor func-
tions ara disabled.
hf you ara using fhe optional RC-848 remote control
unit, you can switch the insert and the auto input
monitor functions on/off separate/y
I
NOTE
The shuttle monitor is not available unless both the
insert and the auto input monitor modes are acti-
vated.
To activate or disable the shuttle monitor function :
1 Press SHIFT and the associated LED will start blink-
ing to show that all the double function keys are
switched to offer their lower bhelabelled functions.
rKl
LiA-..!
2 Press MENU as many times as necessary to access a
shuttle monitor menu which looks like “5 t L.G OFF ‘I.
3 Press either the A or the V key to change the W F ”
to ” ul-4 ‘1.
4 Press SHIFT and the associated LED will turn off, the
display being switched back to show the ABS time.
l To disable the shuttle monitor mode, press either
the A or the 7 key at the shuttle monitor menu
to change the “0 n I1 display to W F Ia.
9.2