Filter
Top Products
ENGLISH
34
Remote Control Unit 2
Entering a Setup Code
The supplied universal remote control unit can operate not
only this receiver but also up to 7 most popular brands of audio
and video components such as CD players, cassette decks,
TVs, cable boxes, VCRs, DVD players, satellite receivers, and
so on.
To operate components other than this receiver, you should
enter the setup code for each component.
The factory default setup code of CD and DVD is "000". You will
be able to control certain TEAC's CD player and DVD player
with this code. If the code doesn't work, try other codes.
Turn on the component to be controlled.
Pick up the setup code from the list on page 95.
Press and hold down both the ENTER button and the
corresponding REMOTE SELECT button.
CD: CD player
TAPE/MD: cassette tape deck or MD deck
TV: TV
VCR: video tape deck
DVD: DVD player
CABLE: cable box
SAT: satellite receiver
<
The LED will flicker once. If the LED did not flicker, try again.
<
You cannot select the RECEIVER button, as it is exclusive for
the AG-10D receiver.
Pointing the remote control unit towards the remote sensor of
the component, enter the 3-digit setup code using the numeric
buttons.
<
If the code is accepted successfully, the LED will blink twice. If
the LED did not blink twice, try step and again.
<
To check if the entered code is correct, press the POWER,
PLAY, CHANNEL, etc. If the buttons work, the code is correct.
If the buttons don't work, repeat steps to trying each
code for your component until you find one that works.
Manufacturers may use different setup codes for the same
product category. Therefore, it is important to check if the
code you have entered operates as many controls as possible.
If only a few functions operate, check if another code works
with more buttons.
42
43
4
3
2
1
3
4