Filter
Top Products
7.4 Programme Search
As mentioned previously, your receiver is pre-programmed for
all programmes available on the ASTRA and EUTELSAT
satellites. To receive new programmes, or those of other
satellites, several options are available to carry out a
programme search/scan.
1. Satellite:
All, to search all satellites selected in the menu LNB
Settings (Point 5.4) for programmes
Satellite, to scan only the selected satellite for
programmes and bouquets.
2. Transponder:
Select this scan/search function to scan only a specific
transponder of a satellite. This will search for individual resp.
all programmes of a transponder.
3. Manual Search
Use this type of search to search for for specific programmes
for which you have the unique PID numbers available.
When the search has been completed, a display will appear
on your screen, informing you how many programmes were
found and how many of these are new additions.
New programmes will be stored in the Total List. You can
then add them to your Favourites List as described under
Point 7.1.
> To perform a programme search call up the Main
Menu.
(Fig. 7-7)
> Use the arrow keys up/down to mark the item
Search.
> Confirm by pressing OK.
The sub-menu Search will be displayed.
(Fig. 7-8)
> Use the arrow keys up/down to select the type of
search you wish to perform.
7.4.1 Satellite
Activating this type of search will scan all active satellites
(Point 5.4) and transponders for programmes.
> Use the arrow keys up/down to select the menu line
Satellite.
> Press OK to display the corresponding sub-menu.
(Fig. 7-9)
> Press OK again to open the selection table for the
active satellites.
> Use the arrow keys up/down to mark the menu line
All, to search all active satellites for programmes, or
mark a specific satellite to search only this satellite for
programmes.
28
(Fig. 7-7)
(Fig. 7-8)
(Fig. 7-9)
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 28