Filter
Top Products
26 Service Search
You should set the Search Mode option to Auto at the first ser-
vice search after installing the digital receiver. The digital re-
ceiver will search all available services with automatic search
mode. Transponder numbers range from 6 to 12 at VHF and
28 to 69 at UHF.
To search a certain transponder, set the Search Mode option
to Manual, and select your desired transponder at the Channel
parameter.
To search one service of a transponder, set the Search Mode
option to Advanced, and specify the PIDs of your desired ser-
vice at the PID menu with the numeral buttons. PID (Packet
Identifier) is a set of numbers that identifies transport stream
packets.
To start service search, select the Service Search command.
Then appears a list box, in which found services will be listed.
Press the
✄
✂
✁
OK button to save found services when service search
has been completed. To stop service search on the way or exit
without saving, press the
✄
✂
✁
EXIT button.
4.2 Resetting to factory settings
The digital receiver maintains the following data:
• Service list
• Favorite list
• Timer events
• Preference settings
You can reset all data of the digital receiver. To reset all the
data, select the Installation > Factory Setting menu. Then a
confirmation box appears. With the Yes reply, service entries,
favorite entries and timer events will be all deleted, and pref-
erence parameters will be reset to the manufacturer’s factory
settings.