Filter
Top Products
28
LZ196 (E/F) Web 213:276
Chapter 4: Setting up your TV
Setting the time and date
Note: If you already set up the TV Guide On Screen
™
system,
the time and date were set automatically and you can skip this
step.
To set the time and date:
1 Press Y and open the Setup menu.
2 Highlight Installation and press T.
3 (A new set of Installation menu icons will appear, as
shown below.) Open the Time And Date menu,
highlight Start Setup, and press T.
If you have not set up the TV Guide On Screen
™
system,
the following screen will appear. To set the time, highlight
TV Guide On Screen
™
and press T. The TV Guide
On Screen
™
setup sequence will start, and the time and
date will be set automatically.
If you have already set up the TV Guide On Screen
™
system, or if you have not set up the time, the Time and
Date setting screen will appear and you will need to
manually set the time and date.
Note:
• If you highlight TV Guide On Screen
™
(above) to set the
time and date through the TV Guide On Screen
™
system and
a power outage occurs, the time and date will be updated
automatically when the power is restored.
• If you highlight Manual (above) to set the time and date
manually and a power outage occurs, you will lose the time
and date settings when the power is restored.
• If you manually set the time and date and then perform
TV Guide On Screen
™
setup, the manual time and date
settings will be overridden by the TV Guide On Screen
™
settings.
Setting the HDMI
™
audio mode
To set the HDMI audio mode:
1 Press Y and open the Setup menu.
2 Highlight HDMI 1 Audio and press c.
3 Press b or B to select the HDMI audio mode (Auto,
Digital, or Analog) and press T. (Auto is the
recommended mode.) See “Connecting an HDMI or DVI
device to the HDMI input” (- Installation Guide).
Note: Because the PC IN and HDMI (DVI) IN inputs share the
same set of analog audio inputs, the PC Audio menu setting
influences the HDMI 1 Audio menu setting. If PC Audio is set
to “No,” the HDMI 1 Audio setting changes to “Auto.” If PC
Audio is set to “Yes,” the HDMI Audio setting is set to “Digital”
and is grayed out in the menu. (Also see item 4 on page 9 and
“Setting the PC Audio mode” on page 52.)
CH RTNENTER
EXIT
Navigate
Select
Back Exit
Time And Date
Start Setup
Cancel
Time And Date
Manual
TV Guide On Screen
Your TV Guide On Screen system can provide accurate
time and date information.
It is recommended you set up TV Guide On Screen
first and use it to obtain the time and date.
In the event that your TV Guide On Screen system
has acquired time, the television will use network
acquired time rather than manually enterred time.
Cancel
Date (MM/DD/YY)
Time (HH:MM)
Done
Time And Date
:11 11
AM
/06 30/05
CH RTNENTER
EXIT
Navigate
Select
Back Exit
Analog
Digital
Auto
Installation
Sleep Timer
PC Settings
On/Off Timer
Setup
PC Audio
Auto
2 Sec
HDMI 1 Audio
No
Slide Show Interval
LZ196_EN.book Page 28 Tuesday, August 1, 2006 6:04 PM