Filter
Top Products
53
LZ196 (E/F) Web 213:276
Chapter 5: Using the TV’s features
Displaying TV status information
using RECALL
To display TV status information:
Press E on the remote control.
The following information will display (if applicable):
• Current input (ANT 1, ANT 2, VIDEO 1, etc.)
• If ANT 1 or ANT 2 is the current input, either “CABLE”
(for cable TV) or “TV” (for over-the-air broadcasts).
• Channel number (if in ANT 1 or ANT 2 mode)
• Digital signal strength indicator (bar graph in lower right
corner of screen; for ATSC signal only)
• Time (if set)
• On timer setting (if set)
• Remaining time on game timer (if set)
• Remaining time on sleep timer (if set)
• Stereo or SAP audio status
• V-Chip rating status
• Picture size
• Video resolution
To close the RECALL screen:
Press E again.
Understanding the auto power off
feature
The TV will automatically turn itself off after approximately
15 minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT 1 and ANT 2 modes only.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the TV, the
Last Mode Memory feature automatically turns on the TV
when the power is resupplied.
Note: You should unplug the TV’s power cord if it is possible
that you will be away from the TV for an extended period of time
after the power is restored. This will prevent the TV from turning
on automatically in your absence.
STEREO
CABLE
81-1
ANT 1
NC-17
Sleep Timer: 18 min.
Game Timer: 28 min.
Natural
480i
5:32 pm
Sample RECALL screen
LZ196_EN.book Page 53 Tuesday, August 1, 2006 6:04 PM