Filter
Top Products
34
LZ196 (E/F) Web 213:276
Chapter 5: Using the TV’s features
To tune to a channel or input in Select mode:
1 While watching TV, press 3 C or # c to open the
Channel Browser
™
and surf back to a previous item or
forward to the next item in the list.
In Select mode, when you stop on an item in the
Channel Browser
™
, it will be highlighted but you must
press T to tune the TV to the highlighted item.
2 Press O to close the Channel Browser
™
.
Adding and clearing channels and inputs in the
History List
Adding channels and inputs to the History List:
As a channel or input is tuned, the Channel Browser
™
adds it
to the History List and displays it on the “right side” of the
Channel Browser
™
. Previously tuned channels/inputs are
“shifted” to the left, eventually moving off the left side. Press
3 C to surf backward through the previously tuned channels/
inputs. Any channel or input that is tuned repeatedly will not
be repeated in the History List, but instead is moved to the end
of the list on the right side of the Channel Browser
™
.
The Channel Browser
™
will store the following channels:
• All channels that are tuned using the numeric buttons on the
remote control.
• All channels that are tuned using < or , on the remote
control for at least 5 seconds.
• All inputs that are tuned for at least 5 seconds.
Note: Whenever an item is selected that cannot be tuned (for
various reasons), the TV will automatically tune to the
previously viewed channel or input.
Clearing channels from the History List:
• Reconfiguring the ANT 1 or ANT 2 input will clear the
History List.
Note: See page 25 for details on configuring the antenna
inputs.
•
Removing the CableCARD
™
will clear the History List.
• Once 32 channels or inputs are stored in the History List, the
oldest item will be removed from the list when a new
channel or input is tuned.
• If History List in the Channel Browser Setup is set to
“Power Off Clear (On),” turning off the TV will clear the
History List.
Tuning to the next programmed channel
To tune to the next programmed channel:
Press < or , on the remote control or TV control panel.
Note: This feature will not work unless you program channels
into the TV’s channel memory (- page 26).
Tuning to a specific channel (programmed
or unprogrammed)
Tuning analog channels:
Press the Channel Number buttons (0–9) on the remote
control. For example, to select channel 125, press 1, 2, 5.
Tuning digital channels:
Press the Channel Number (0–9) on the remote control,
followed by the dash (=) and then the sub-channel number.
For example, to select digital channel 125-1, press 1, 2, 5, –, 1.
Note: If a digital channel is not programmed—either through
the automatic channel scan (- page 26) or the channel add/
delete function (- page 27)—you will have to tune the RF
channel using the Channel Numbers and dash (=) on the
remote control.
Inputs
Channel Browser
ANT 1 CABLE 4 AAA 480i
ClrStrmHD1
Satellite..
__ __
1
ANT 1
ClrStrmHD2
Video 2
HDMI 1
LZ196_EN.book Page 34 Tuesday, August 1, 2006 6:04 PM